Craft Project: Fake Built in Bookcase

I love to read. It is one of my favorite past times to curl up with a good book, take a break from the real world, and escape into the sea of words held in the pages of my most recent reading adventure.

My reading obsession has broaden my world, without ever having to leave my house. But, it is has constricted my closet. My poor books, with nowhere to go, have ended up in boxes filling every closet in my house. I longed for a bookcase to display them, but our small house has little space for the book trophy case I require.

After two years of racking my brain for any available space to display my books, it finally hit me. The space behind our bedroom door at the top of the stairs was a dead space. A small nook, with nothing there. It was a small, narrow space, useless for most things, but perfect for a bookcase.

Nick and I have done A LOT of projects around our house, which has also caused our bank account to sag a bit. My need for a bookcase was trumped by our bank accounts need to withhold funds. However, I was impatient, and as usual I found a way to get it done right away. Rather than spend a lot of time and money constructing a bookcase from scratch I did some research and found two pre-fab bookcases from Target that fit perfectly. I loved the look of the two cases next to each other because it not only filled the space but it also looked more like a unique, custom built bookcase.

Below are the supplies and set-by-step instructions on how I completed this DIY, home improvement, craft project. All you need are a few basic tools, and basic knowledge on how to work them. Due to my impatience (in life and with this project) I decided I wanted to get this project done in one weekend, which also happened to be a weekend Nick was out of town. I am proud to say I did this 100% on my own, which shows how easy it was!

SUPPLIES

• Pre-fab bookcase


• Box cutter


• Paint scrapper


• Pry bar


• Hammer


• Scrap wood


• Nails


• Screws


• Dry wall mollies


• Screwdriver


• Circular Saw


• Caulk


• Paint


• Paint brush

HOW TO:

STEP 1: Remove the molding from the wall. I had never done this before and was afraid I would break the molding or punch a hole in the wall. I had to take a minute to allow my impatience to subside before I started my research, gathered my tools, and prepped before I jumped right in.

• First use a box cutter to slice the caulk between the molding and the wall.


• Then use a metal scrapper to wedge between the molding and the wall. Wiggle it slowly to loosen the board and the nails.


• Once you create a space between the molding and wall place a scrap piece of wood on the wall and a pry bar in the space. Slowly pry the molding off with the pry bar, making sure to put pressure on the scrap wood on the wall. This will disperse the weight and prevent the pry bar from punching a hole in the wall.


• Use a hammer to remove all of the nails.


• I used a great website to help me with the process, check it out here!

STEP 2: Pre-fab bookcase… While looking around for the perfect case I found that the cheapest places to find bookcases are Target, Walmart, and IKEA. If you are flexible on color and size the process won’t be too difficult. Since I had a very specific size space and wanted a white bookshelf, it took a few weeks plus an in store and online purchase to get what I needed.

• Put together your bookcase according to the directions that came with it.


• Place the bookcase in the area you want to install them.


• Make any adjustments necessary, make sure the bookcase is level.  (Living in a 1940′s home there are a lot of odd things in my house, including uneven walls. I had to place a scrap piece of wood under the front legs of the bookcase in order to push the bookcase against the wall.).


• Use a screwdriver to create holes through the bookcase and into the wall, to create a pilot hole for the dry wall mollies, and to make it easier to insert screws. When doing this always make sure the drill bit you use is slightly smaller than the screw you are using.


• Place dry wall mollies where they are needed and use screws to attach the bookshelves to the wall.

STEP 3: Reattaching the molding… I had to take my existing molding and re-cut it in order to piece it together on the front of the bookshelf.

• Using a circular saw make any adjustments necessary to piece the molding together on the front of your bookshelf. In order to create a clean look on the corners cut the molding at 45 degree angles.


• Attach the molding to the front of the bookcase and nail it with finishing nails.


• Spackle on top of the nails heads in order to make them blend in.


• Caulk the top edge of the molding to create a clean look.

STEP 4: Finishing…

• Spackle over any holes in the bookshelf. If you are 100% satisfied with the placement of the shelves, Spackle over the shelf adjustment holes in order to make it look like a custom built shelf.


• Paint the molding to cover up the Spackle, paint the shelf where it is necessary.


• Put your books on display!

 

 

 

 

 

 

Craft Project: Fake Built in Bookcase

Visual Journal Page 8: That was Going to be My Kitchen Table

It all started with a grill out. It was Fall, the weather was amazing, we were finally settled into our house, and the decorating was coming along, which meant it was time to host our first house party. Nick and I sat down and decided to have a rib cook off, the first annual rib off of hopefully many more to come. I couldn’t wait to host our first party, and it encouraged me to tie up a few loose ends, hanging up pictures, organizing rooms, and doing my first post-move-in deep clean of the house. It was a whirlwind the day of the rib off, I was preparing for the multiple rib entries that were heading our way, the a slew of people who were coming, and I was frantically cleaning, cooking, and prepping. The cook out was a huge success, everyone had a good time, Nick won the rib competition, and although the cost of the party brought our bank account down a little, it was worth it. If only I knew what was coming next….

Post-party the house was a mess, dirt was tracked in and out of the back door, it seemed like all of the silverware, pots, pans, glasses, and plates were dirty, there wasn’t a trace of the deep clean I did pre-party. The following morning I dragged myself out of bed and downstairs to face the wreck our house had become. I spent the second day in a row deep cleaning, and by the end of Sunday I collapsed onto the sofa, and allowed myself to relax before work the next day.

With my cleaning frenzy and Sunday night deep relaxation I didn’t pay too much attention to Jacob and Kody Bear. After all, I convinced myself, they got so much attention at the party, everyone loving on them, giving them treats here and there, I could let them rest and it would be okay. I assumed Kody was being lethargic because he was as exhausted as I was, he was partied out, he spent all day outside the day before, and didn’t want to go outside because he wanted indoor time. If only I knew…

I got up Monday morning, still recovering from the weekend, and took the pups on their morning walk. Jacob did his business immediately, and I waited as patiently as I could for Kody to do his. I waited and waited, continuously checking my watch, counting down the last minutes and seconds before I absolutely had to be out the door. I looked at Kody, shook my head, and said “I guess you will just have to hold it until I get home, it’s not my fault you are going to be uncomfortable all day”.  With those last annoyed words I put the dogs inside, grabbed my much needed coffee, and headed out the door.

I have no idea what happened at school that day, what project my classes were on, if anyone acted up or said something sweet, all I remember is coming home, walking in the door and seeing blood splattered on the floor in the living room. My heart dropped, the air rushed out of my lungs, I immediately called for my babies, terrified that something bad had happened, only assuming the worse. Jake ran right in, Kody followed much slower. I checked them both out, every nook and cranny, and found nothing. I sent them outside, and went to work cleaning up the mystery massacre in my living room.

I was still freaking out, I had no idea what was going on, until I looked outside to check on the pups and saw Kody in an endless squat. Something had disagreed with him, something was making him bleed. In my head I immediately returned to the party and saw all of the handouts he was given, the rib bones, the easily accessible trash can, with even more rib bones. I ran to my computer and looked up the affects of a dog eating bones, and of course my imagination ran wild with all of the ridiculous stories people posted, I was convinced my baby was going to die from a punctured stomach or small intestine, I imagined blood filling him up, him keeling over, all from a stupid cook out.

By the time Nick got home I was practically in tears, we loaded him in the car and sped of to the emergency vet. We frantically waited in the waiting room for Kody to be called back. We finally made it to the tiny examination room and I felt terrible as they took Kody back to get blood work done and to be examined. It felt like hours, but finally the doctor came back with her prognosis. He was fine. Yes, he probably ate some rib bones which splintered and probably cut him a little on the way out, which caused the blood. Yes, he was a little bit backed up, but it would pass. In the end Kody got some antibiotics, a couple cans of soft food, and was 100% okay. On the other hand, Nick and I got a very long lecture about giving dogs bones and a $400.00 vet bill for antibiotics and a 15 minute check up.

I was beyond relieved when he was fine, and showed absolutely no signs of the previous mess over the next few days. However, every now and then I would stop, and gaze at the bare area in the kitchen that was meant to have a table. I would think about the $400.00 that literally went into Kody’s butt and how that could’ve been the kitchen table (and chairs at that price) that I had been dreaming of and wishing for. Although we could’ve skipped the vet visit and the ridiculous bill and Kody would’ve been fine, I would still do it all over again. I don’t think I could’ve ever forgiven myself if something had gone wrong and I didn’t do anything about it because of money. My dogs are my babies, I would fork over more money than I have to save their lives if it came down to it. And in the end, even though I didn’t have my table, I still had my baby, and that is all that matters.

SUPPLIES:

• Visual Journal


• Rubber cement


• Scissors


• Pencil


• White paper


• Sharpie


• Gesso


• Watercolor or bleeding tissue paper


• Vet pamphlets

HOW TO

As soon as this fiasco happened, I began thinking of how I would incorporate it into my visual journal. I had already been brainstorming ways to incorporate a skeleton into a page, I love the way they look, and it seemed to fit perfectly with what happened. I considered drawing a picture of Kody, with an x-ray in front of him, drawing an entire dog skeleton, or a pile of rib bones. That got me thinking about rib bones, I don’t think any bone in our body is as interesting as our rib cage. I love the shape, the curves, and the space it creates as the bones wrap from back to front. This train of thought prompted me to look up images of dog rib cages, which brought me to the idea of creating a medical diagram of just a rib cage. After all, it was the perfect visual. The rib bones were the downfall, and they ended up passing through his rib cage and into his stomach. Inside the rib cage drawing I would place the pamphlet the vet forced on us about what not to feed your dog, which we will pass out to all of our guests the next cook out we have.

I started by drawing the rib cage on a separate sheet of white paper. I used pencil, erased a lot, and went through multiple drafts before it was perfect. Once the proportions were correct, I decided to add value. I wanted it to look more graphic, so I scribbled with a sharpie to create the cast shadows between the overlapping bones. I liked the effect, but I wanted more gray. I brainstormed ideas, but I knew I couldn’t erase the black sharpie that was already there, so I had to cover it up with something else. Immediately I thought of gesso. I watered some down, and tested a small area. It look perfect, it toned it down to a lighter gray, but you could still see the scribbles. I coated the rest of the rib cage in gesso, let it dry, and went back one more time with the sharpie to punch up the dark shadows. I carefully cut the rib cage out with scissors, and used an Xacto knife for the small interior areas. To learn more about gesso click here.

After the drawing was complete I glued down the pamphlet and rib cage. In order to push the paper into the crease of the book I used a credit card, and ran it along the crease before the glue dried. I knew I wanted to splatter red watercolor for blood. Coming home to the blood splatter is something I will never forget, and it had to be included in the page. I chose the right corner, put a drop of red paint down, and blew it to create the splatter. To finish the page I added words on top of the splatter with sharpie, and labeled the bones to make it look like a medical diagram.

CHALLENGE:

Create a page that incorporates a skeleton. Use an animal, human, or even an insect exoskeleton. Play with the position of the bones, do a close up or a far away drawing. Have fun with it!

I hope you enjoyed my post! If you have any questions or comments please contact me! If you like my blog, help me spread the word like, tweet, link over, or subscribe! Thanks for your help getting the word out about visual journals!

Visual Journal Page 8: That was Going to be My Kitchen Table